You have five shop tabs open, and every kettlebell in them looks alike: a ball of iron with a handle, in a dozen weights and four finishes. The question "which kettlebell should I buy" has a short answer. Buy one single-piece cast iron kettlebell with a smooth, powder-coated handle, in the weight you will deadlift, goblet squat and swing with. For many women that is 8 to 12 kg (18 to 26 lb), for many men 12 to 16 kg (26 to 35 lb). Below you get the reasons for that pick, a handle and base check, the bells to skip and the moment a second bell earns its place, so you can order in ten minutes.
Which kettlebell should you buy first? One cast iron bell in your lower-body weight
Your first bell is for the lower body. The deadlift, the goblet squat and the swing use your legs and hips, the muscles that move the most load, and they show up in nearly every kettlebell workout. A bell chosen for those three lifts gets used in every session. Take the lighter end of the range if you are new to strength training and the heavier end if you have lifted before. Overhead presses usually need a lighter bell, and that one can wait. Our guide on what kettlebell weight to start with sets out the numbers lift by lift.
A bell at the lighter end teaches you a flat back. At the bottom of a deadlift, a bell that is too heavy drags your shoulders forward, and your lower back rounds to finish the lift. Each rep in that shape is practice, so the rounded hinge becomes the movement your body knows. With a bell you control, you can pause at the bottom, feel your back flat and stand up with your hips doing the work. That position is what you load later. Kettlebells usually go up in steps of 4 kg (9 lb), so the next bell is one order away once the position holds.
Before the first session, run your fingers along the whole handle and feel for burrs or sharp casting marks. Then give the bell two minutes: 10 deadlifts with a flat back and 8 goblet squats with your chest up, side-on to a mirror if you have one. If your lower back rounds on the deadlift, reset: bell between your feet, hips back, shins vertical, push the floor away, and try 5 more reps. If it still rounds, or your chest still folds on the squat, the bell is too heavy to learn with, and one size lighter is the bell to train with now. If you have any doubt about your health, check with a doctor before you start.
The swing comes after the deadlift. A Beginner in the Living Room Athlete app starts with the Dead-Stop Swing: the bell parks on the floor between reps, and you reset a flat back before every hike. The Two-Hand Swing, where the bell keeps moving from rep to rep, starts at Intermediate, about 20 good swings without a break. Before any swing, clear 2 meters in front of you and 1 meter to each side, face open floor or a bare wall, keep children and pets out of that space, dry your hands and put a mat or rug where the bell lands. Stop the set on sharp pain in a joint or when your form breaks down (lower back rounds, hips sag, heels lift). If you feel dizzy, nauseous or unwell, stop, sit down and check with a doctor before you train again. Chest pain, pain spreading to your arm, jaw or back, fainting, severe or sudden shortness of breath or a sudden severe headache means you stop at once and get medical help straight away. Set the bell down with bent knees and a flat back. If a bell gets away from you, step clear and let it land. Never try to catch it.
Choose cast iron for home training and competition steel for high-rep snatch work
Both common types are one piece of metal. They differ in size and in the handle.
Competition kettlebells are hollow steel, and they keep the same outer size at every weight. The handle stays the same as the weight goes up, usually about 33 to 35 mm thick. For someone who trains long sets of snatches and jerks, that consistency matters: the bell sits in the same spot on the forearm at a light weight and at a heavy one, so the technique carries over each time you move up.
Cast iron kettlebells grow with the weight, so a light bell is small and a heavy one is large. They cost less per kilogram, and the light sizes take up less room on the floor. Their handle window is usually wider, which gives room for a two-hand grip in the swing and the goblet hold.
For most people training at home, powder-coated cast iron is the pick. Buy competition steel if you already know you want sport-style sets of snatches and jerks. In the app the snatch and the jerk are Advanced lifts, and a cast iron bell handles them too. Competition steel pays off when you train long timed sets.
Check the handle and the base before buying a kettlebell
Most of what makes a kettlebell pleasant to train with sits in the handle. You can check it from the product photos and the description, then confirm it with your hands on delivery.
Look for a bell cast in one piece, with the handle and body poured together. Run a thumb along the handle: it should be smooth all the way round, with no seam or ridge from the mold. A ridge sits exactly where your palm grips in the swing. The finish matters as much. Powder coat has a slight texture that holds a sweaty hand. Glossy paint and vinyl get slippery when hands sweat.
Two measurements decide the handle. Its width should give both hands room side by side, because the swing, the deadlift and the goblet squat all use a two-hand grip; our kettlebell swing form guide shows how the hands sit. Its thickness should be one you can close your hand around. Most handles sit between 30 and 40 mm, and smaller hands often prefer the thinner end. The window, the gap between handle and body, should let your hand slide through, so the bell can rest on the back of your forearm in the clean and the press later.
Then check the base. Set the bell on a hard floor and press down on each side of the handle. It should sit flat without rocking. A flat base keeps the bell still for rows that start from the floor, such as the Dead-Stop Row, and lets you set the bell down quietly. Put a rubber mat or a rug where the bell lands, set it down with bent knees, and never drop it.
Buy an adjustable kettlebell only if the maker rates it for swings and overhead work
An adjustable kettlebell holds several weights in one shell, and in a small apartment that saved shelf space counts. Before you buy one, read the manufacturer's instructions for what the bell is rated for. Some models are made for swings, cleans and overhead lifts, and the manual says so. Follow that rating for each of those lifts.
Once it is home, check the lock before every set. Never swing with a loose plate. If anything rattles or shifts during a set, let the swing die down, park the bell softly in front of you and check the lock before the next rep.
Expect a bulkier bell at the light settings, since the shell keeps the size it needs for the heaviest weight. A light setting sits wider against your forearm in the rack and between your thighs in the swing. Changing the weight also takes a moment, so plan one setting per exercise in a timed workout.
Skip vinyl-coated, sand-filled and two-piece kettlebells
Three kinds of bell show up in every shop search, and each has a problem you will feel in training.
Vinyl- and plastic-coated bells have a shell over a core. The shell gets slippery when your hands sweat, and the seam where the halves meet often runs along the handle and rubs your palm. Sand- or cement-filled bells are plastic shells with a heavy filling. They are bulky for their weight, and the handle shape is often off: too thick, too short for two hands or set at an odd angle. Two-piece bells have a handle welded or screwed onto the body, and that joint can work loose over months of swings.
Watch the low end of a weight range too. A 4 kg bell is fine for the Kettlebell Halo and for warm-ups, and too light for swings and deadlifts for most adults. If a starter set tempts you, the smallest bell in it is the one you will use least.
Buy the second kettlebell when 20 swings with the first one feel easy
The kettlebell to buy next is one size up, 4 kg heavier than your first: from 8 to 12 kg (18 to 26 lb), 12 to 16 kg (26 to 35 lb), 16 to 20 kg (35 to 44 lb) or 20 to 24 kg (44 to 53 lb). In pounds, the next bell is about 9 lb heavier. The heavier bell takes over swings, deadlifts and goblet squats. The first bell takes over rows, and presses too if you can press it for 5 clean reps on each arm. If you cannot, your press bell is 4 kg lighter. Test the press only where the bell clears the ceiling and any light fixture with your arm locked out, and lower the bell to the rack if you feel a sharp pain in a shoulder, elbow or wrist or have to lean back to finish the press. With two sizes in the house, every exercise has a bell that fits it.
The swing gives the signal. Once you have moved from the Dead-Stop Swing to the Two-Hand Swing, count your swings in one set. About 20 good swings without a break is the app's marker for Intermediate. When 20 Two-Hand Swings with your first bell feel easy, with a flat back and a sharp hip snap from the first rep to the last, that bell has done its job for your lower body. The press can give the signal too. If the swing still takes everything you have and the press with your first bell is stuck below 5 clean reps on each arm, the bell you are missing is a lighter one, usually 4 kg down (8 kg for a first bell of 12 kg, 12 kg for a first bell of 16 kg).
A matching pair comes later, for double work such as the Double Front Squat and the Double Press. When you get there, the app keeps track of what you own. It is an Android app for structured home workouts with kettlebells and body weight: over 2,000 workouts, built on professional strength and conditioning principles. You enter the bells you own, and for every exercise the app suggests which of them to use; with one bell, it adjusts the reps. Two-bell exercises start at Intermediate, except the Double Deadlift and the Double Row, which start at Beginner.
For what to do once the bell is on your floor, our full-body workout with one kettlebell gives you a session built around a single bell.
Whichever bell arrives at your door, the app builds each workout around the bells you own.
Questions people ask
Should I buy a full kettlebell set right away?
Start with one bell, or two at most. A set includes sizes you will skip for months, often a 4 kg (9 lb) bell that is too light for swings and deadlifts and a top bell that is too heavy to learn with. Buy your lower-body bell first and add the next one when 20 swings with it feel easy.
How do I protect the floor under a kettlebell?
Put a rubber mat or a rug where the bell lands, and train on it every session. Set the bell down with bent knees and a flat back, and never drop it. A bell with a flat base sits still on the mat and goes down quietly.
What handle size should a kettlebell have?
Pick a handle you can close your hand around, with room for both hands side by side. Most handles sit between 30 and 40 mm thick, and smaller hands often prefer the thinner end. Check that the window lets your hand slide through, so the bell can rest on your forearm in the clean and the press later.
Are competition kettlebells good for beginners?
They work for beginners, with a handle of about 33 to 35 mm and the same outer size at every weight. Cast iron costs less per kilogram and usually has a wider window that fits a two-hand grip for the swing. Choose competition steel if you already know you want high-rep snatch work.